Marshall Electronics Network Control Box for IMD Monitors NCB-1004 Betriebsanleitung

Marshall Electronics NCB-1004 Network Control Box for IMD Monitors Operating Instructions

10 Changing the IP Address of the NCB-1004 Overview The NCB-1004 is shipped with a default IP address of 192.168.0.233. This IP address can be chan

11 Changing the IP Address of the NCB-1004 (continued) Procedure (continued) 5. At the password prompt shown below, do not enter a password and

12 Changing the IP Address of the NCB-1004 (continued) Procedure (continued) 8. The following file information should appear:

13 System Configuration Overview The NCB-1004 can be used in three different system configurations. The following diagrams show the different conf

14 System Configuration (continued) Remote Control with Image Video Pass-Through Overview Use the following configuration for basic remote cont

15 System Configuration (continued) Remote Control with TSL Pass-Through Overview Use the following configuration for basic remote control of M

16 Web Interface Overview The web interface is used to operate the NCB-1004. Once the NCB-1004 is connected to a network, access the web interface

17 Web Interface (continued) Window Management The Window Management page is shown below: Use the buttons and menus shown above fo

18 Web Interface (continued) Preset Configuration The Preset Configuration page is shown below: Use the buttons shown above to load an

19 Web Interface (continued) OSD Configuration & IMD The OSD Configuration & IMD page is shown below: Use the f

20 Web Interface (continued) System The System page is shown below: Use the buttons shown above to send the following commands:

21 Web Interface (continued) Table of Web Interface Commands Aspect Ratio 4:3, Scaled 4:3, 16:9, 16:9 Centered Set Marker Off, On Wi

22 Specifications CONTROL INPUT Connector 1 x RJ12 (Modular 6P6C) Physical Layer RS-422 Data Protocols Image Video: Start Bit

Specifications (continued) Warranty Marshall Electronics warranties to the first consumer that this NCB-1

Marshall Electronics, Inc. 1910 East Maple Ave. El Segundo, CA 90245 Tel: (80

3 3ContentsProduct Overview...

4 Product Overview The NCB-1004 Network Control box is a comprehensive remote control solution for Marshall’s IMD (In-Monitor Display) line of monito

5 Installation and Power-On Unpacking Carefully unpack the NCB-1004 and verify that the following items are included: • NCB-1004 Network Co

6 Front and Rear Panel Features RS-422 Outputs The RS-422 outputs send MEI protocol commands to Marshall’s IMD line of monit

7 Connecting to the NCB-1004 Overview The NCB-1004 can be operated by any computer with a web browser, via a TCP/IP network connection. No additio

8 Connecting to the NCB-1004 (continued) Connecting the NCB-1004 to a Single Computer (continued) 8. Click OK in the Internet Protocol (TCP/IP) Pr

9 Connecting to the NCB-1004 (continued) Connecting the NCB-1004 to a Local Area Network If the network portion of the unit’s IP address (first th